Tool

Cross stitch calculator: fabric size, needle and floss by count

Type the stitch count from your pattern and pick a fabric. The calculator gives the size of the stitched design, the piece of fabric to cut, and the needle and strands for that count.

Stitched size by stitch count

28, 32 and 36 count stitched over 2 read the 14, 16 and 18 count columns.

Cross stitch calculator

Enter the stitch count from your pattern and pick the fabric. Switch to "Will it fit my fabric?" to check a piece you already own. Add the number of full crosses to get a skein estimate.

How the numbers are worked out

Count is the number of stitches per inch, so the size of a stitched design is plain division: stitches divided by count gives inches, and inches times 2.54 gives centimeters. One stitch is 25.4 mm divided by the count, which is 1.81 mm on 14 count. Design sizes are rounded to 0.1 in and 0.1 cm.

The fabric to cut is the design size plus the margin on both sides, rounded up to the next half inch (or the next whole centimeter in cm mode). For 140 x 100 stitches on 14 count with 3 in per side that is 10.0 + 6 = 16 in by 7.14 + 6 = 13.14 in, rounded up to 13.5 in.

The needle size comes from published needle charts, which list 6 count = size 18, 8 count = 20, 11 count = 22, 14 count = 24, 16 count = 26 and 18 count = 28. A count that falls between those rows gets the nearest standard size, and the result says so. Strands are the usual figures from a published table by count: 3 on 11 count, 2 on 14 and 16 count, 1 or 2 on 18 count. Sources differ by one strand, so treat both as starting points.

The skein figure is a model, not a measurement. A cross worked in rows uses two diagonal legs on the front and two straight legs on the back, about 4.83 stitch widths of thread, which is roughly 8.8 mm per cross on 14 count. A skein is 8 m of six strands, so 2 strands give 24 m of working thread, or about 2,740 crosses on paper. Real stitching loses thread to starts, finishes, the thickness of the fabric, tails too short to use and travelling on the back. The calculator allows for that by showing 40 to 65 percent of the paper figure, rounded down to a multiple of 50: about 1,050 to 1,750 crosses for 14 count with 2 strands.

That band is an allowance, not a measured constant. It was set so the result sits inside the spread of published figures for 14 count with 2 strands, about 1,000 to 1,850 full crosses per skein. Your own figure depends on how you start, finish and travel.

How to work out cross stitch fabric size by hand

  1. 1

    Divide the stitches wide by the fabric count. That is the width in inches: 140 divided by 14 is 10 in.

  2. 2

    Do the same for the stitches high: 100 divided by 14 is 7.1 in.

  3. 3

    For evenweave or linen stitched over 2, halve the count first: 28 count over 2 works as 14.

  4. 4

    Add the margin twice to each measurement, once for each side: 10 + 6 = 16 in and 7.1 + 6 = 13.1 in.

  5. 5

    Round up to a size you can cut or buy: 16 x 13.5 in. For centimeters, multiply inches by 2.54.

How much margin to leave

Leave at least 3 in (8 cm) of fabric on every side of the design. The margin gives the hoop or frame something to grip near the edges of the design and leaves enough to mount or back the piece when it is finished. A framer may ask for more. Set the margin to 0 only when you want the bare design size.

Aida vs evenweave: what "over 2" does to the numbers

Aida is woven in blocks and takes one cross per block, so its count is the stitch count per inch. Evenweave and linen are usually stitched over 2 threads, which halves the count: 28 count over 2 gives the same stitch size as 14 count aida, 32 count matches 16 and 36 count matches 18. Stitched over 1, 28 count gives 28 stitches per inch and the 140 x 100 design shrinks to 5.0 x 3.6 in. The aida count chart compares the common counts side by side.

How many skeins will I need

A pattern key usually lists the number of stitches for each color. Divide a color's full crosses by the per-skein range above, or type the number into the calculator, and run each large color separately. Buy toward the high end for large single-color areas, because a skein bought later can come from a different dye lot. How many cross stitches per skein has the table by count and strands.

Charts that go with this calculator

Where the numbers come from

The size arithmetic is exact. Needle, strands and skeins are the usual recommendations and an estimate: your pattern and the maker's instructions win where they differ.