How to cross stitch: step by step for complete beginners
Published
As an Amazon Associate we earn from qualifying purchases. This does not change our picks. Affiliate disclosure
New to Prime? Try Prime free for fast, free shipping on eligible items.
Gear for this job
All 7 picks comparedSnowman Counted Cross Stitch Kit with Hoop
See price on AmazonSee it on AmazonKraftex Stamped Cross Stitch Kit, Rose Poppy
See price on AmazonSee it on AmazonDesign Works Friends Cross Stitch Kit
See price on AmazonSee it on Amazon
To cross stitch, you make small X-shaped stitches on aida fabric, one per square, following a chart. Separate two strands of floss, bring the needle up at the bottom left of a square, go down at the top right, then come up at the bottom right and go down at the top left. Repeat square by square, keeping every top leg slanting the same way, and secure the thread ends under stitches on the back instead of tying knots. The steps below cover supplies, setup and the two main stitching methods.
What you need to start
Five things: 14 count aida cloth, six-strand embroidery floss in the colors on your chart, a size 24 tapestry needle, a hoop or frame about 6 to 8 inches across, and small sharp scissors. A chart or kit completes the set. A kit is the easiest start because everything matches and the floss comes sorted by color.
Cut the fabric with at least 3 inches of margin around the design on every side. A design 70 stitches wide is 5 inches on 14 count, so the fabric should be at least 11 inches wide. Tape or zigzag the edges so they do not fray while you work.
Step 1: prepare the fabric and floss
Fold the aida in half lengthwise and then widthwise to find the center, and mark it with a pin or a short basting stitch. Find the center of the chart from the arrows on its edges. Put the fabric in the hoop, centered on the starting point, and tighten until it is firm but not stretched out of square.
Cut a length of floss about 18 inches long. Floss is made of six strands; pull one strand straight up out of the end while holding the rest, and it will slide out cleanly. Pull out a second strand the same way and put them back together. On 14 count aida you stitch with two strands. Thread the needle.
Step 2: start without a knot
Knots make lumps under framed work and can pull through aida. The loop start is the neatest beginning: take one strand of double length, fold it in half and thread the two cut ends through the needle. Come up from the back at your first stitch, leaving the loop hanging, make the first half stitch, and pass the needle through the loop on the back before pulling snug.
If you are using an odd number of strands, hold a one inch tail against the back of the fabric and catch it under your first four or five stitches instead. Either way, the thread is held securely without a knot.
Step 3: make the stitches
Each cross is two diagonal half stitches. The usual direction is first leg from bottom left to top right, second leg from bottom right to top left. What matters is consistency: every top leg in the whole piece should slant the same way, or the surface looks uneven.
There are two methods. In the Danish or row method, work a row of first legs across all the squares of one color in a row, then come back along the row completing the Xs. It is fast and gives a neat back, best for large areas. In the English method, complete each X before moving on, which is better for scattered single stitches and diagonal lines. Keep the fabric taut and let the floss lie flat without pulling hard; the stitch should sit on the surface and fill the square.
Step 4: finish a thread and move on
When about 3 inches of floss remain, bring the needle to the back and slide it under the backs of three or four stitches nearby, ideally of the same color, then trim the tail close. Do not carry floss more than a few squares across bare fabric on the back, because it can show through. End the thread and start again instead.
Stitch one color at a time in a small area, then move to the next. Count new stitches from ones you have already made, using the bold lines every ten squares on the chart as checkpoints. Work backstitch outlines last, with one strand, so they lie on top of the crosses.
Common beginner problems
Twisted, knotting floss: let the needle hang and spin freely every few stitches, and keep lengths around 18 inches. Gaps showing between stitches: you may be pulling too tight, or the fabric is a higher count than the strand number suits. Puckered fabric: loosen your tension and make sure the hoop is evenly tight.
Stitches in the wrong place: unpick them with the needle tip from the back, or snip carefully on the front and pull the pieces out with tweezers. Aida recovers well from unpicking. Hoop marks fade with a gentle wash and a press face down on a towel when the piece is done.
Frequently asked questions
How many strands of floss do I use for cross stitch? Two strands on 14 count aida, three on 11 count, and one or two on 16 and 18 count. Backstitch usually uses one.
Which way should cross stitches cross? It does not matter which way, as long as every top stitch slants in the same direction across the whole piece.
Do I need a hoop for cross stitch? It helps keep stitches even, but small pieces on stiff aida can be stitched in hand. Many stitchers prefer a Q-Snap frame for larger pieces.
What size needle do I use for cross stitch? A blunt tapestry needle, size 24 for 11 and 14 count, size 26 for 16 and 18 count.
What you need for this
- See price on AmazonAmazon
Snowman Counted Cross Stitch Kit with Hoop
From Best cross stitch kits for beginners: small counted and stamped starters
- See price on AmazonAmazon
DMC GD1436-0322 Gold Label Aida Fabric, 14 Count
From Best 14 count aida cross stitch fabric: brands, cuts and colors
- See price on AmazonAmazon
DMC 1767-24 Tapestry Hand Needles, Size 24
From Best cross stitch needles: tapestry needles in sizes 24, 26 and 28
- See price on AmazonAmazon
DMC six-strand floss, 36 popular colors, 8.7 yd
From Best embroidery floss for hand embroidery: brand sets compared